Fujitsu D3028-A1
Only one machine has reported its memory so far, so this answer rests on a single example. Check the label or open the panel before you buy.
Yes. 4 slots, up to 8 GB seen working.
It takes DDR3-1600 full-size sticks (DIMM).
- Slots
- 4 DIMM slots
- Type
- DDR3-1600 240-pin DIMM
- Most seen working
- 8 GB in the one machine reported
- Firmware says
- 8 GB maximum
- How sure
- 1 of 1 report show this layout
Worked out from 1 hardware report of this desktop. Sources and method. Updated 10 Nov 2026.
Check the drive you have.
The reports don't show this model's drive type yet. Look at the drive in it: a 2.5-inch box, about 7 by 10 cm, is SATA. A small stick is M.2, and its label says NVMe or SATA and its length (2230, 2242 or 2280).
- Drive type
- Check your current drive
How to tell a drive's type. Sources and method. Updated 10 Nov 2026.
Illustration Check the label on the power supply.
We don't have this model's power supply rating. It is printed on the supply's sticker, inside the case next to its fan. Prebuilt desktops often use a supply shaped for their case, so match the shape and the plugs as well as the watts. Small cases take a slim supply.
- Rating
- On the supply's label
How to read a power supply label. Sources and method. Updated 10 Nov 2026.
Illustration Check the processor socket.
The reports don't name this desktop's processor or socket yet. In Windows, System Information shows the processor model; the maker's spec page lists the socket and the processors the machine supports.
- Socket
- Not in the reports yet
How to find the processor and socket. Sources and method. Updated 10 Nov 2026.
Illustration It has a full-length (x16) slot for a graphics card.
100% of these machines report a small case. A small case takes low-profile cards only, and its power supply may not feed a card that needs its own power cable.
- x16 slots
- At least 1, listed by the firmware
- Case
- 100% report a small case
From the firmware's slot table. Sources and method. Updated 10 Nov 2026.
Illustration Questions
Can I upgrade the RAM in the Fujitsu D3028-A1?
Yes. 4 slots, up to 8 GB seen working. It takes DDR3-1600 full-size sticks (DIMM).
What type of RAM does the Fujitsu D3028-A1 use?
DDR3-1600 full-size sticks (DIMM, 240-pin).
How much RAM can the Fujitsu D3028-A1 take?
Machines in the reports run up to 8 GB. That matches the 8 GB maximum the firmware reports.
Can I add a graphics card to the Fujitsu D3028-A1?
It has a full-length (x16) slot for a graphics card. 100% of these machines report a small case. A small case takes low-profile cards only, and its power supply may not feed a card that needs its own power cable.
Is this my desktop?
Check the model name on the front or the label of the case. It should read D3028-A1.